If you didn’t need to replace the roof substrate, cut a patch of tar paper or rubber roll roofing 12 in (30 cm) wider and longer than the mended section. Finally, use a trowel to apply roof cement over the nail heads and edges of the new shingle.Ĭover the repaired area with a patch of roll roofing.Slide the new shingle into place, gently lift the shingle above, and drive 1 1⁄ 4 inch (3.2 cm) galvanized roofing nails into the new shingle’s corners.Now replace the nails that you removed from the shingle above.After removing the old shingle, use a sharp utility knife to round the back corners of the new shingle this makes it easier to install. If necessary, use a blow dryer to make the surrounding shingles more pliable.Now use your pry bar and insert it way under the shingle you are replacing all the way to the nails holding it down and with a gentle force pry the shingle to loosen the nails, now use the pry bar or hammer to remove the nails, you will also need to remove the nails from the shingles above as the nails will also be holding down the shingle you are replacing, once all nails are out slide shingle out, then scrape the area beneath to remove any leftover roofing cement. To replace a shingle, carefully lift the front edge of the shingle you are replacing and the one above it with a pry bar. If part or all of a shingle is missing, head to the hardware store to find a matching replacement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |